Instead of sometimes re-running minibp/the primary builder during the
next phase, run bpglob earlier to check dependencies.
We've run into issues where the environment is slightly different
between bootstrapping phase and the main build phase. It's also a
problem because our primary builder (Soong) exports information used by
another tool (Kati) that runs in between the bootstrapping phases and
the main phase. When Soong would run in the main phase, it could get out
of sync, and would require the build to be run again.
To do this, add a "subninja" include a build-globs.ninja file to each
build.ninja file. The first time, this will be an empty file, but we'll
always run minibp / the primary builder anyway. When the builder runs,
in addition to writing a dependency file, write out the
build-globs.ninja file with the rules to run bpglob.
Since bpglob may need to be run very early, before it would normally be
built, build it with microfactory.
Change-Id: I89fcd849a8729e892f163d40060ab90b5d4dfa5d
We're already going to load the .ninja_deps file, so we may as well use
it. These are the only two files in our build that don't.
Test: dump the .ninja_deps file, see the dependencies
Having separate .ninja_log files doesn't work very well after
04d886b110
since the last successful timestamp is not recorded in the ninja log.
This was triggering the primary builder to be run twice on every build
since it was always considered out of date in the primary, then main
stages.
The two bootstrap stages already were unified when minibootstrap was
simplified, but this combines the main stage as well. This means that
we'll save some time running globs that are shared between minibp and
the primary builder as well (subdirs globs).
The cleanup code needed to be refactored, since the ninja_log will have
entries from the main stage as well. So instead of looking at everything
in the ninja log, take a string prefix to limit what we may clean.
Change-Id: I8d43168643aa8a0c6c3e48c6101eaa45d174bbe5
This duplicates building common blueprint go packages between minibp and
the primary builder, but drastically simplifies the first stage,
removing the need to check in a generated build.ninja.in.
Change-Id: I639a9637f1ed36d4210823ef276c0f7a064a83bd
