No device ships libhfp_pal on stock, so silence the following error:
08-26 09:13:26.159 1242 1242 E AHAL: AudioExtn: hfp_feature_init: 499: dlopen failed with: dlopen failed: library "/vendor/lib64/libhfp_pal.so" not found
Change-Id: Idf6b6f72f15b792dc5dfc95f24511bfbe54bdc69
* This is to allow supporting WiFi 6 mobile hotspots,
to be noted this is only supported on SDM855+ platforms.
Change-Id: Iab61bd12499968e8823b3078acd1c7b8bce46136
debug.stagefright.ccodec=4
is the default value in frameworks.
debug.stagefright.omx_default_rank=0
was used to rank OMX SW codecs lower than OMX HW codecs
but we have removed all OMX SW codecs now.
Change-Id: Idf55ec02c2c0f4d2fa73f949cffef0d820a54570
These are no longer available as of Android 14 QPR3. The C2 codecs
available by default in the swcodec apex will be used instead.
Change-Id: I8cdf3e700823779a7382c66c3df8410d41209b7c
In Android 14, prioritization of partitions is emphasized, diverging
from previous versions where priorities were respected universally.
Overlay precedence now plays a critical role, with the following
partition order dictating overlay precedence:
- system
- vendor
- odm
- oem
- product
- system_ext
When multiple overlays contend for the same resources, the order of
overlays becomes crucial. An overlay takes precedence over others if it
has configurations following its own. This prioritization, while
impactful for GSI compatibility, is essential for maintaining order and
functionality.
Change-Id: I8b7568dcc418dbbd1ccb39e2d0dc66504f19fcdd
The bootloader sets androidboot.hwversion, use this and set the ro.boot.hardware.revision property in order to show it in settings.
Change-Id: I3c6c678bf055091ea9fcb2a1524d321e2c1be043
Despite forcing prebuilt audio HAL to be copied at the very end,
it's still built from sources along with all dependencies,
including the non-qmaa manifests.
Change-Id: I64a3611d6ea7b6d013d21dbf2df2b9b4c34963e6
Instead, we provide the isMiuiRom method via xiaomi-telephony-stub
The permissions patches for com.qti.permission.BIND_QTI_IMS_SERVICE
and com.qualcomm.qti.permission.USE_EXT_TELEPHONY_SERVICE don't
seem to be needed without injection.
Change-Id: Ifd904b845efa3e89dda89cedb6b495f61ca3308f
* In cape (msm-5.10) pmic driver now lies in adsp [1], so
adsp firmware must to be loaded along with qti battery/
charger kernel module, in order to get battery and usb
power_supply up & running
* With this, we dont need to set usb mode to peripheral
explicitly either
* The GKI kernel for 5.10 explicitly disabled
FW_LOADER_USER_HELPER_FALLBACK, and the right way to enable it is to
echo 1 to the /proc/sys/kernel/firmware_config/force_sysfs_fallback,
so do this before writing to adsp sysfs node.
[1]: 4e2b0f663a
Depends-On: Id0e64302dbbdc53620cbc1825c36e13bb9e58aef
Change-Id: I835fa5daaa53eb704cc6c0777d7069d47ecbe10c
